Ready to drive chevy C20 pickup with most of the work already done.
I acquired this truck a few years ago in a package deal and it’s time for it to move on to a new owner. It arrived with the 283 on a pallet and machine work receipts from the late 80s after spinning a main bearing. It was in the process of being rebuilt but that was stopped and put into storage.
Once we get the truck, the motor was broken down and inspected the work which was good with no rust or damage. Every seal on the block was replaced with stuff from Fel-Pro. The 3 speed transmission was also pulled and cleaned/resealed with FelPro 5190 kit.
The rear axles were pulled to reseal the axles tubes and all of the brake components were rebuilt or replaced, including the hardline over the rear axle.
The fuel system was also removed, cleaned and rebuilt with new parts. I try to use OEM or USA made parts and avoid Chinese made just junk this is poorly made so,
with a few exceptions, any part replaced has been domestic.
It has a brand new brass Modine radiator, hoses, heater core/hoses and water pump. New alternator, battery, battery cables, brake master cylinder, throw out bearings, motor mounts, turned brake drums, rebuilt slave cylinders, exhaust gaskets, u joints, spark plugs, plug wires, cap/rotor/points, fuel pump, brake shoes, oil filter update kit to modern spin on style filters, C10 style side mirrors, factory bumper bolts, light bulbs, headlamps, vac advance unit, rebuilt carb, fan shroud, hood weatherstripping, shift boot/seals, wiper blades, new windshield & gasket.
As for tires we bolted up a set that was pulled off a mid 2000s Chevy 2500 HD truck. The rims are aluminum Alcoa 8 lug with tires and special lug nuts so the modern hubcaps can be attached to them.
Price: $9,500
More info: Click here to see original eBay auction and get more information (Affiliate link)
Seller's other items: oldjunkhunter64 (Affiliate link)
Location: Fullerton, California, United States
